Spanning Tree Protocol Modes; Global Stp Control - Lenovo ThinkSystem NE2552E Application Manual

Spanning Tree Protocol Modes

Global STP Control

174
NE2552E Application Guide for ENOS 8.4
Lenovo ENOS 8.4 supports the following STP modes:
 Rapid Spanning Tree Protocol (RSTP)
IEEE 802.1D (2004) RSTP allows devices to detect and eliminate logical loops in
a bridged or switched network. When multiple paths exist, STP configures the
network so that only the most efficient path is used. If that path fails, STP
automatically configures the best alternative active path on the network in order
to sustain network operations. RSTP is an enhanced version of IEEE 802.1D
(1998) STP, providing more rapid convergence of the Spanning Tree network
path states on STG 1.
See "Rapid Spanning Tree Protocol" on page
 Per‐VLAN Rapid Spanning Tree (PVRST+)
PVRST mode is based on RSTP to provide rapid Spanning Tree convergence, but
supports instances of Spanning Tree, allowing one STG per VLAN. PVRST
mode is compatible with Cisco R‐PVST/R‐PVST+ mode.
PVRST is the default Spanning Tree mode on the NE2552E. See "PVRST Mode"
on page 175 for details.
 Multiple Spanning Tree Protocol (MSTP)
IEEE 802.1Q (2003) MSTP provides both rapid convergence and load balancing
in a VLAN environment. MSTP allows multiple STGs, with multiple VLANs in
each.
See "Multiple Spanning Tree Protocol" on page
By default, the Spanning Tree feature is globally enabled on the switch, and is set
for PVRST mode. Spanning Tree (and thus any currently configured STP mode)
can be globally disabled or re‐enabled using the following commands:
NE2552E(config)# spanning-tree mode disable
Spanning Tree can be re‐enabled by specifying the STP mode:
NE2552E(config)# spanning-tree mode {pvrst|rstp|mst}
The NE2552E switch supports two maximum number of Spanning Tree Groups
(STGs): 128 or 256. The default value is 128. To configure the maximum number of
Spanning Tree Groups (STGs) that can be used on the switch, use the following
command:
NE2552E(config)# boot spanning-tree max-instances {128|256}
Note: The switch needs to be reloaded for the configuration to take effect.
187 for details.
189 for details.
(Globally disable Spanning Tree)