Lenovo ThinkSystem NE2552E Application Manual page 49

5. Enter Q to reboot the switch:
6. After the reload is complete, log into the switch by using the default user admin
with the default password admin.
7. Enter configuration mode (config). Copy the active configuration to the running
configuration by using the copy active-config running-config
admin-pw-bypass command.
8. Use the show run command to confirm the configuration is recovered. Set the new
admin and enable passwords. Save the running configuration to startup
configuration.
9. Make sure the boot configuration‐block is active. If it is not active, change the boot
configuration‐block with the following command:
© Copyright Lenovo 2018
Boot Management Menu
I - Change booting image
C - Change configuration block
R - Boot in recovery mode (xmodem download of images to recover
switch)
Q - Reboot
E - Exit
Please choose your menu option: q
Resetting the board.
NE2552E> ena
Enable privilege granted.
NE2552E# configure terminal
Enter configuration commands, one per line. End with Ctrl/Z.
NE2552E(config)# copy active-config running-config admin-pw-bypass
Loading to current configuration.
NE2552E(config)# password
Changing admin password; validation required:
Enter current local admin password:
Enter new admin password (max 64 characters):
Re-enter new admin password:
New admin password accepted.
Password changed and applied, but not saved.
Notifying administrator to save changes.
NE2552E(config)# enable password ?
WORD The UNENCRYPTED (cleartext) 'enable' password
NE2552E(config)# enable password admin1
NE2552E(config)# copy running-config startup-config
Confirm saving to FLASH (y/n) ? y
Copy running configuration to startup configuration
Switch is currently set to use factory default config block on next boot.
Do you want to change that to the active config block (y/n) ? y
Next boot will use active config block.
NE2552E(config)# boot configuration-block active
Chapter 1: Switch Administration
49