vLAG Peer Gateway
214
NE2552E Application Guide for ENOS 8.4
vLAG Peer Gateway allows a vLAG switch to act as the active gateway for packets
that are addressed to the router MAC address of the vLAG peer. The feature
enables local forwarding of such packets without crossing the ISL trunk, therefore
improving ISL usage and avoiding potential traffic loss.
To make it functional, vLAG Peer Gateway must be configured on both vLAG peer
switches.
By default, the feature is disabled. To enable it, use the following command:
NE2552E(config)# vlag peer-gateway
Use the no form of the command to disable vLAG Peer Gateway.
To display information about the current vLAG Peer Gateway settings, use the
following commands:
NE2552E(config)# show vlag
NE2552E(config)# show vlag peer-gateway