Configuration Guidelines
Configuration Example
1. Select a VLAN and define the Private VLAN type as primary.
2. Configure a promiscuous port for VLAN 700.
3. Configure two secondary VLANs: isolated VLAN and community VLAN.
4. Map secondary VLANs to primary VLAN.
152
NE2552E Application Guide for ENOS 8.4
The following guidelines apply when configuring Private VLANs:
Management VLANs cannot be Private VLANs. Management ports cannot be
members of a Private VLAN.
The default VLAN 1 cannot be a Private VLAN.
IGMP Snooping must be disabled on Private VLANs.
All VLANs that comprise the Private VLAN must belong to the same Spanning
Tree Group.
A VLAN pair is a primary VLAN and one associated secondary VLAN (isolated
or community). The maximum number of VLAN pairs per port is 16.
Follow this procedure to configure a Private VLAN.
NE2552E(config)# vlan 700
NE2552E(config-vlan)# private-vlan primary
NE2552E(config-vlan)# exit
NE2552E(config)# interface port 1
NE2552E(config-if)# switchport mode private-vlan
NE2552E(config-if)# switchport private-vlan mapping 700
NE2552E(config-if)# exit
NE2552E(config)# vlan 701
NE2552E(config-vlan)# private-vlan isolated
NE2552E(config-vlan)# exit
NE2552E(config)# vlan 702
NE2552E(config-vlan)# private-vlan community
NE2552E(config-vlan)# exit
NE2552E(config)# vlan 700-702
NE2552E(config-vlan)# stg 1
NE2552E(config-vlan)# exit
NE2552E(config)# vlan 700
NE2552E(config-vlan)# private-vlan association 701,702
NE2552E(config-vlan)# exit