Changing the LLDP Transmit State
468
NE2552E Application Guide for ENOS 8.4
When the port is disabled, or when LLDP transmit is turned off for the port using
the admstat command's rx_only or disabled options (see "Transmit and
Receive Control" on page
time‐to‐live value of 0. Neighbors that receive this packet will remove the LLDP
information associated with the NE2552E port from their MIB.
In addition, if LLDP is fully disabled on a port (using admstat disabled) and
later re‐enabled, the NE2552E will temporarily delay resuming LLDP
transmissions on the port in order to allow the port LLDP information to stabilize.
The reinitialization delay interval can be globally configured for all ports using the
following command:
NE2552E(config)# lldp reinit-delay <interval>
where interval is the number of seconds to wait before resuming LLDP
transmissions. The range is between 1 and 10. The default is 2 seconds.
465), a final LLDP packet is transmitted with a