Lldp Example Configuration - Lenovo Flex System Fabric CN4093 Application Manual

LLDP Example Configuration

1. Turn LLDP on globally.
2. Set the global LLDP timer features.
3. Set LLDP options for each port.
4. Enable syslog reporting.
5. Verify the configuration settings:
6. View remote device information as needed.
© Copyright Lenovo 2017
CN 4093(config)# lldp enable
CN 4093(config)# lldp refresh-interval 30
CN 4093(config)# lldp transmission-delay 2 (No more often than 2 sec.)
CN 4093(config)# lldp holdtime-multiplier 4
CN 4093(config)# lldp reinit-delay 2
CN 4093(config)# lldp trap-notification-interval 5
CN 4093(config)# interface port <n>
CN 4093(config-if)# lldp admin-status tx_rx (Transmit and receive LLDP)
CN 4093(config-if)# lldp trap-notification
CN 4093(config-if)# lldp tlv all
CN 4093(config-if)# exit
CN 4093(config)# logging log lldp
CN 4093(config)# show lldp
CN 4093(config)# show lldp remote-device
or
CN 4093(config)# show lldp remote-device <index number>
or
CN 4093(config)# show lldp remote-devices detail
(Transmit each 30 seconds)
(Remote hold 4 intervals)
(Wait 2 sec. after reinit.)
(Minimum 5 sec. between)
(Select a switch port)
(Enable SNMP trap notifications)
(Transmit all optional information)
Chapter 35: Link Layer Discovery Protocol
553