Using Juniper Perl Client - Lenovo ThinkSystem NE2552E Application Manual

Using Juniper Perl Client

1. Extract the file juniper-netconf-perl-client.zip to the folder
2. Follow these steps to install the Juniper Perl client:
504
NE2552E Application Guide for ENOS 8.4
You can use Juniper Perl client instead of BNClient to communicate with the
NETCONF feature on the switch. Follow these steps to use the Juniper Perl client.
Note: You must use the Linux operating system for the Juniper Perl client.
/home/user/.
You will see two folders:
juniper-netconf-perl-client

blade-netconf-perl-scripts

As a Perl library:
a. Change to the following directory:
/home/user/juniper-netconf-perl-client
b. Extract the following file:
netconf-perl-10.0R2.10.tar.gz
c. Change to the following directory:
/home/user/juniper-netconf-perl-client/netconf-perl-10.0R
2.10
d. Install the client as per the instructions in the README file.
Note: If the prerequisites package installation fails, manually install each file in
/home/user/juniper-netconf-perl-client\netconf-perl-prereqs-
patch.
As a Perl script:
a. Change to the following directory:
/home/user/blade-netconf-perl-scripts/
b. Enter the following command:
perl get/get.pl -l admin -p admin {swich IP address}
Note: get.pl is an example of a NETCONF operation Perl script. You can edit the
script or write a new script as per your requirement.