Static Multicast Router
1. For each Mrouter, configure a port, VLAN, and IGMP version of the multicast
router.
2. Verify the configuration.
© Copyright Lenovo 2018
A static multicast router (Mrouter) can be configured for a particular port on a
particular VLAN.
A total of 128 static Mrouters can be configured on the NE2552E. Both internal and
external ports can accept a static Mrouter.
Note: When static Mrouters are used, the switch will continue learning dynamic
Mrouters via IGMP snooping. However, dynamic Mrouters may not replace static
Mrouters. If a dynamic Mrouter has the same port and VLAN combination as a
static Mrouter, the dynamic Mrouter will not be learned.
Following is an example of configuring a static multicast router:
NE2552E(config)# ip igmp mrouter EXT5 1 2
NE2552E(config)# show ip igmp mrouter
Chapter 25: Internet Group Management Protocol
361