Lenovo ThinkSystem NE2552E Application Manual page 73

5. If required by the FTP, SFTP or TFTP server, enter the appropriate username and
password.
6. The switch will prompt you to confirm your request.
7. When loading is complete, use the following commands to enter Global
Configuration mode to select which software image (image1 or image2) you want
to run in switch memory for the next reboot:
8. Reboot the switch to run the new software:
© Copyright Lenovo 2018
The exact form of the name will vary by server. However, the file location is
normally relative to the FTP, SFTP or TFTP directory (for example, tftpboot).
Once confirmed, the software will begin loading into the switch.
Router# configure terminal
Router(config)# boot image {image1|image2}
The system will then verify which image is set to be loaded at the next reset:
Next boot will use switch software image1 instead of image2.
Router(config)# reload
The system prompts you to confirm your request. Once confirmed, the switch
will reboot to use the new software.
Chapter 3: Switch Software Management
73