Lenovo ThinkSystem NE2552E Application Manual page 459

Task 2: Configure NE2552E 2
1. On NE2552E 2, configure the interfaces for clients (174.14.20.111) and servers
(10.1.1.111).
2. Configure Virtual Interface Routers.
3. Enable VRRP Hot Standby.
4. Configure VRRP Group parameters. Use the default VRRP priority of 100, so that
this switch is the Standby.
5. Turn off Spanning Tree Protocol globally. .
© Copyright Lenovo 2018
NE2552E(config)# interface ip 1
NE2552E(config-ip-if)# ip address 174.14.20.111 (Define IPv4 address for interface 1)
NE2552E(config-ip-if)# enable
NE2552E(config-ip-if)# exit
NE2552E(config)# interface ip 2
NE2552E(config-ip-if)# ip address 10.1.1.111 (Define IPv4 address for interface 2)
NE2552E(config-ip-if)# enable
NE2552E(config-ip-if)# exit
NE2552E(config)# router vrrp
NE2552E(config-vrrp)# enable
NE2552E(config-vrrp)# virtual-router 1 virtual-router-id 1
NE2552E(config-vrrp)# virtual-router 1 interface 1
NE2552E(config-vrrp)# virtual-router 1 address 174.14.20.100
NE2552E(config-vrrp)# virtual-router 1 enable
NE2552E(config-vrrp)# virtual-router 2 virtual-router-id 2
NE2552E(config-vrrp)# virtual-router 2 interface 2
NE2552E(config-vrrp)# virtual-router 2 address 10.1.1.100
NE2552E(config-vrrp)# virtual-router 2 enable
NE2552E(config-vrrp)# hot-standby
NE2552E(config-vrrp)# group enable
NE2552E(config-vrrp)# group virtual-router-id 1 (Set Virtual Router ID for Group)
NE2552E(config-vrrp)# group interface 1 (Set interface for Group)
NE2552E(config-vrrp)# group track ports (Enable tracking on ports)
NE2552E(config)# spanning-tree mode disable
(Enable Virtual Router Group)
Chapter 32: Virtual Router Redundancy Protocol
459