Neighbor Configuration Example - Lenovo ThinkSystem NE2552E Application Manual

Neighbor Configuration Example

1. Configure IPv6 interface parameters:
2. Enable OSPFv3:
3. Define the backbone.
4. Configure neighbor entry:
© Copyright Lenovo 2018
When using NBMA or point to multipoint interfaces, you must manually configure
neighbors. The following example includes the steps for neighbor configuration.
NE2552E(config# interface ip 10
NE2552E(config-ip-if)# ipv6 address 10:0:0:0:0:0:0:12 64
NE2552E(config-ip-if)# vlan 10
NE2552E(config-ip-if)# enable
NE2552E(config-ip-if)# ipv6 ospf area 0
NE2552E(config-ip-if)# ipv6 ospf retransmit-interval 5
NE2552E(config-ip-if)# ipv6 ospf transmit-delay 1
NE2552E(config-ip-if)# ipv6 ospf priority 1
NE2552E(config-ip-if)# ipv6 ospf hello-interval 10
NE2552E(config-ip-if)# ipv6 ospf dead-interval 40
NE2552E(config-ip-if)# ipv6 ospf network point-to-multipoint
NE2552E(config-ip-if)# ipv6 ospf poll-interval 120
NE2552E(config-ip-if)# ipv6 ospf enable
NE2552E(config-ip-if)# exit
NE2552E(config# ipv6 router ospf
NE2552E(config-router-ospf3)# router-id 12.12.12.12
NE2552E(config-router-ospf3)# enable
NE2552E(config-router-ospf3)# area 0 area-id 0.0.0.0
NE2552E(config-router-ospf3)# area 0 stability-interval 40
NE2552E(config-router-ospf3)# area 0 default-metric 1
NE2552E(config-router-ospf3)# area 0 default-metric type 1
NE2552E(config-router-ospf3)# area 0 translation-role candidate
NE2552E(config-router-ospf3)# area 0 type transit
NE2552E(config-router-ospf3)# area 0 enable
NE2552E(config-router-ospf3)# neighbor 1 address
fe80:0:0:0:dceb:ff:fe00:9
NE2552E(config-router-ospf3)# neighbor 1 interface 10
NE2552E(config-router-ospf3)# neighbor 1 priority 1
NE2552E(config-router-ospf3)# neighbor 1 enable
417
Chapter 28: OSPF