3. Add each IP interface to the appropriate VLAN.
4. Verify the configuration.
320
NE2552E Application Guide for ENOS 8.4
Each time you add a port to a VLAN, you may get the following prompt:
Port 4 is an untagged port and its current PVID is 1.
Confirm changing PVID from 1 to 2 [y/n]?
Enter y to set the default Port VLAN ID (PVID) for the port.
Now that the ports are separated into three VLANs, the IP interface for each subnet
must be placed in the appropriate VLAN. From Table
follows:
NE2552E(config)# interface ip 1
NE2552E(config-ip-if)# vlan 2
NE2552E(config-vlan)# exit
NE2552E(config)# interface ip 2
NE2552E(config-ip-if)# vlan 1
NE2552E(config-ip-if)# exit
NE2552E(config)# interface ip 3
NE2552E(config-ip-if)# vlan 1
NE2552E(config-ip-if)# exit
NE2552E(config)# interface ip 4
NE2552E(config-ip-if)# vlan 3
NE2552E(config-ip-if)# exit
NE2552E(config)# show vlan
NE2552E(config)# show interface information
NE2552E(config)# show interface ip
Examine the resulting information. If any settings are incorrect, make the
appropriate changes.
28, the settings are made as
(Select IP interface 1)
(Add VLAN 2)
(Select IP interface 2)
(Add VLAN 1)
(Select IP interface 3)
(Add VLAN 1)
(Select IP interface 4)
(Add VLAN 3)