Example 3: Tunnel Mode; Example 4: Fcoe Mode - Lenovo ThinkSystem NE2552E Application Manual

Example 3: Tunnel Mode

1. Turn on UFP.
2. Configure internal port as UFP.
3. Configure virtual port.
4. Configure vPort tunnel mode.
5. Configure vPort default VLAN.
6. Specify the QoS parameters for the vPort.
7. Enable the vPort.
8. Configure tagging of ingress frames with the port's VLAN ID on external port 1.

Example 4: FCoE Mode

© Copyright Lenovo 2018
Following is an example configuration of UFP vPorts in tunnel mode.
NE2552E(config)# ufp enable
NE2552E(config)# ufp port INTA1 enable
Warning: "Tagging/Trunk-mode" is enabled on UFP port INTA1
NE2552E(config)# ufp port INTA1 vport 1
NE2552E(config_ufp_vport)# network mode tunnel
NE2552E(config_ufp_vport)# network default-vlan 4000
NE2552E(config_ufp_vport)# qos bandwidth min 15
NE2552E(config_ufp_vport)# qos bandwidth max 95
NE2552E(config_ufp_vport)# enable
NE2552E(config_ufp_vport)# exit
NE2552E(config)# interface port EXT1
NE2552E(config-if)# tagpvid-ingress
NE2552E(config-if)# no vlan dot1q tag native
NE2552E(config-if)# switchport access vlan 4000
NE2552E(config-if)# exit
Following is an example configuration of UFP vPorts in FCoE mode.
This example is consistent with the network shown in .
(in percentage)
(in percentage)
Chapter 19: Unified Fabric Port
297