Enabling Or Disabling Lldp; Global Lldp Setting; Transmit And Receive Control - Lenovo ThinkSystem NE2552E Application Manual

Enabling or Disabling LLDP

Global LLDP Setting

Transmit and Receive Control

© Copyright Lenovo 2018
By default, LLDP is enabled on the NE2552E. To turn LLDP off or on, use the
following command:
NE2552E(config)# [no] lldp enable
The NE2552E can also be configured to transmit or receive LLDP information on a
port‐by‐port basis. By default, when LLDP is globally enabled on the switch,
NE2552E ports transmit and receive LLDP information (see the tx_rx option
below). To change the LLDP transmit and receive state, the following commands
are available:
NE2552E(config)# interface port <x>
NE2552E(config-if)# lldp admin-status tx_rx (Transmit and receive LLDP)
NE2552E(config-if)# lldp admin-status tx_only (Only transmit LLDP)
NE2552E(config-if)# lldp admin-status rx_only (Only receive LLDP)
NE2552E(config-if)# no lldp admin-status
NE2552E(config-if)# exit
To view the LLDP transmit and receive status, use the following commands:
NE2552E(config)# show lldp port
NE2552E(config)# show interface port <n> lldp (status of selected port)
(Turn LLDP on or off globally)
(Select a switch port)
(Do not participate in LLDP)
(Exit port mode)
(status of all ports)
Chapter 33: Link Layer Discovery Protocol
465