Example 5: Tunnel Mode - Lenovo CN4093 Application Manual

8. Enable vPort.
9. Configure the Edge Virtual Bridging profile.
10. Configure the Edge Virtual Bridging database.

Example 5: Tunnel Mode

1. Turn on UFP.
2. Configure internal port as UFP.
3. Configure virtual port.
4. Configure vPort tunnel mode.
5. Configure vPort default VLAN.
6. Specify the QoS parameters for the vPort.
© Copyright Lenovo 2015
CN4093(config_ufp_vport)# enable
CN4093(config_ufp_vport)# exit
CN4093(config)# virt evb profile 1
CN4093(conf-evbprof)# reflective-relay
CN4093(conf-evbprof)# vsi-discovery
CN4093(conf-evbprof)# exit
CN4093(config)# virt evb vsidb 1
CN4093(conf-vsidb)# host 10.100.48.20
CN4093(conf-vsidb)# filepath vsitypes
CN4093(conf-vsidb)# exit
Note: VLANs in the database are dynamically added by 802.1Qbg.
Following is an example configuration of UFP vPorts in tunnel mode.
CN 4093(config)# ufp enable
CN4093(config)# ufp port INTA1 enable
Warning: "Tagging/Trunk-mode" is enabled on UFP port INTA1
CN4093(config)# ufp port INTA1 vport 1
CN4093(config_ufp_vport)# network mode tunnel
CN4093(config_ufp_vport)# network default-vlan 4000
CN4093(config_ufp_vport)# qos bandwidth min 15
CN4093(config_ufp_vport)# qos bandwidth max 95
(in percentage)
(in percentage)
Chapter 21: Unified Fabric Port
355