When Using Floor Jack - Suzuki WagonR+ RB310 Service Manual

0A-22 GENERAL INFORMATION

When using floor jack

WARNING:
If the vehicle to be jacked up only at the front or rear end,
be sure to block the wheels on ground in order to ensure
safety.
After the vehicle is jacked up, be sure to support it on
stands. It is extremely dangerous to do any work on the
vehicle raised on jack alone.
CAUTION:
Never apply jack against suspension parts (i.e., stabilizer
(3), etc.), front bumper (4) or vehicle floor, or it may get
deformed.
When lifting front vehicle end with floor jack, be sure to put the
wooden block (5) on the jack against front jacking bracket (1).
When lifting rear vehicle end with floor jack, be sure to put the
jack against the center portion of rear axle (2) (2WD vehicle) or
rear axle housing (6) (4WD vehicle).
To perform service with either front or rear vehicle end jacked up,
be sure to place safety stands (1) under vehicle body so that vehi-
cle body is securely supported. And then check to ensure that
vehicle body does not slide on safety stands (1) and the vehicle is
held stable for safety's sake.
[A]: Front
[B]: Rear