Precaution For Installing Mobile Communication Equipment; Precaution In Servicing Full-Time 4Wd Vehicle - Suzuki WagonR+ RB310 Service Manual

Precaution for Installing Mobile Communication Equipment

When installing mobile communication equipment such as CB (Citizens-Band) -radio or cellular-tele-
phone, be sure to observe the following precautions.
Failure to follow cautions may adversely affect electronic control system.
• Keep the antenna as far away as possible from the vehicle's electronic control unit.
• Keep the antenna feeder more than 20 cm (7.9 in) away from electronic control unit and its wire har-
nesses.
• Do not run the antenna feeder parallel with other wire harnesses.
• Confirm that the antenna and feeder are correctly adjusted.

Precaution in Servicing Full-Time 4WD Vehicle

This full-time 4WD vehicle can not be converted to 2WD manually.
Observe the following caution in servicing. Otherwise, front wheels drive rear wheels or vise-versa and
vehicle accidents, drivetrain damage and personal injury may result.
• Never perform any of the following types of service
work.
[A]: Testing with 2-wheel chassis dynamometer, speed-
ometer tester or brake tester.
[B]: Driving front wheels, which are jacked up.
[C]: Towing under the condition where either front or
rear wheels can not rotate.
• When testing with 2-wheel chassis dynamometer,
speedometer tester or brake tester, be sure to make the
vehicle as front wheel drive by removing propeller shaft.
• When using On-vehicle type wheel balancing equipment
(1), be sure to jack up all four wheels, off the ground
completely and support vehicle with safety stands (2).
Be careful of the other wheels, which will rotate at the
same time.
• This vehicle should be towed under one of the following
conditions:
– With all wheels on a flatbed truck.
– With front or rear wheels lifted and a dolly under the
other wheels.
GENERAL INFORMATION 0A-11