Renault Laguna III Manual page 3174

Structural components to be positioned on the repair bench: Description
It is used when replacing:
- the front impact cross member mounting,
- the front side member completely or partially
10 - End of rear side member
The jig rests under the rear side member and is cen-
tred in the square hole (J) .
It should be used with the mechanical components in
place to realign a rear side member.
It is used with the mechanical components removed,
under the same conditions, to replace the complete
rear side member.
GENERAL INFORMATION
124865
11 - inner rear wheel arch
The jig is centred in the rear shock absorber mounting
yoke and is centred in the mounting hole (E) .
Use it when replacing the rear wheel arch.
40A-44
40A
124866