Renault Laguna III Manual page 3462

Windscreen: Removal - Refitting
Special tooling required
Car. 1819 Instrument panel protector
Note:
When removing and refitting the windscreen, do not
damage the windscreen seal. The seal is not sold
separately.
In this case, use the pneumatic tool for removing
bonded windows (see Technical Note 414A), hav-
ing partially removed the front section of the head-
lining beforehand.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Remove:
- the windscreen wiper arms (see Windscreen wip-
er arm: Removal - Refitting) (85A, Wiping -
Washing),
- the scuttle panel grille (see 56A, Exterior equip-
ment, Scuttle panel grille: Removal - Refitting,
page 56A-1) ,
- the interior rear-view mirror (see 57A, Interior
equipment, Interior rear-view mirror: Removal -
Refitting, page 57A-14) ,
- the windscreen pillar trims (see Windscreen pillar
trim: Removal - Refitting) (71A, Body internal
trim).
a Protect around the windscreen using masking tape.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Position the dashboard protector (Car. 1819) on the
dashboard.
WINDOWS
a
a Cut the cement bead (see Technical Note 560A).
REFITTING
I - REFITTING PREPARATION OPERATION
a Always replace:
- the shims,
- the rain and light sensor adhesive base,
- the safety labels.
a For preparation and bonding (see Technical Note
560A).
II - REFITTING OPERATION FOR PART
CONCERNED
a Bond the windscreen (this operation requires two
people).
a Respect the following clearances and shut lines:
- « windscreen - roof » ,
- « windscreen - A-pillar » .
a Keep the windscreen in position using masking tape.
54A-1
WARNING
When cutting the cement bead, take care not to
cut the wiring harness.
54A
108156