Renault Laguna III Manual page 3300

Body side: General description
B91 or K91 – D91
Note:
The information contained in the following
describes the general repair procedure for all vehi-
cles having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associ-
ated with the vehicle. These special notes are spec-
ified if necessary in other parts of the sub-section
dealing with the component.
Note:
For a detailed description of a particular connec-
tion (see MR 400).
DESIGN OF THE STRUCTURAL COMPONENT
B91 or K91
The two parts must be welded at the joint (1) and butt
welded by continuous EGW welding.
If there are other issues regarding access to mating
faces, the various replacement options are described
in the basic instructions for structural bodywork repair
(see MR 400).
WARNING
If the mating faces of the parts to be welded are not
accessible, make EGW plug welds to replace the
original resistance welds (see MR 400).
SIDE UPPER STRUCTURE
122470
The body side is achieved by welding the rear wing and
the body side front section.
43A-14
43A