Renault Laguna III Manual page 3250

Rear subframe assembly: General description
IMPORTANT
Use a repair bench to ensure the positioning of the
points and the geometry of the axle assemblies.
Note:
The information contained in the following
describes the general repair procedure for all vehi-
cles having the same design for this part.
Before reading this general information, check that
there are no special notes associated with this vehi-
cle. These special notes will be specified if applica-
ble in other parts of this subsection dealing with the
part.
Note:
For a detailed description of a particular connec-
tion, see MR 400.
DESIGN OF THE STRUCTURAL COMPONENT
The special feature of this type of part is that is com-
bines several functional parts made up of made up of
several panels of different types and thicknesses:
- rear section and front section of rear floor
- front cross member of rear floor
- centre cross member of rear floor
- rear side member assembly.
REAR LOWER STRUCTURE
124619
This type of part is used when there has been a large
rear collision (3rd degree) for putting back together the
rear geometry of the vehicle's subframe.
It is carried out on a restructuring bench with geometric
inspection (body jig bench).
41D-13
41D