Renault Laguna III Manual page 3417

NON-SIDE OPENING ELEMENTS
K91
a Connect the number plate light connectors.
a Connect the electrical connectors to:
- the rear screen wiper motor,
- the tailgate lock,
- for the boot lid opening control,
- the heated rear screen.
a Refit the tailgate trim (see Tailgate trim: Removal -
Refitting) (73A, Non-side opening elements trim).
II - REMOVAL - REFITTING WITH THE HINGES
1 - PREPARATION FOR REMOVAL
a Remove the tailgate trim (see Tailgate trim: Re-
moval - Refitting) (73A, Non-side opening ele-
ments trim).
a Disconnect the electrical connectors to:
- the rear screen wiper motor,
- the tailgate lock,
- for the boot lid opening control,
- the heated rear screen,
- the high level brake light.
B91
a Disconnect:
- the earths,
- the aerial connectors,
- the tailgate lights.
K91
a Disconnect the number plate light connectors.
a Remove:
- the tailgate wiring,
- the tailgate washer jet tube,
Tailgate: Removal - Refitting
- the tailgate gas struts (see Tailgate strut: Remov-
al - Refitting) (52A, Non-side opening element
mechanisms),
- the rear section of the headlining (see Headlining:
Removal - Refitting) (71A, Body internal trim).
2 - REMOVAL
a Remove:
- the tailgate hinge nuts (2) ,
- the tailgate.
3 - REFITTING
a Refit:
- the tailgate,
- the tailgate hinge nuts (2) .
a If necessary adjust the tailgate edge clearances
(see 48A, Non-side opening elements, Tailgate:
Adjustment, page 48A-15) .
4 - FINAL OPERATION
a Refit:
- the tailgate gas struts (see Tailgate strut: Remov-
al - Refitting) (52A, Non-side opening element
mechanisms),
- the tailgate washer jet tube,
- the tailgate wiring.
48A-11
48A
122809