Renault Laguna III Manual page 3134

Vehicle on repair bench: Description
III - MAIN REAR TRIM-SETTING REFERENCE
POINTS
1 - Rear mechanical components in place
The jig rests under the rear axle fork and is centred on
the rear axle assembly pilot hole (B) .
Use this situation for a frontal impact or a light rear im-
pact.
2 - Rear mechanical components removed
GENERAL INFORMATION
124330
124866
The jig supports the underneath of the rear axle as-
sembly mounting unit and is centred on the pilot hole
(B) .
Use this situation for a rear impact with removal of the
mechanical components.
Note:
If it is suspected that one of these points may be
deformed, use two additional points located in an
area not affected by the impact in order to confirm
trim-setting.
IV - SECONDARY REAR TRIM-SETTING
REFERENCE POINT
The jig rests under the front side member rear section
and is positioned in the hole (G) .
Use for a major rear impact when replacing the rear
side member assembly.
It is used to confirm the vehicle level in case of doubt
about the deformation of a main rear reference point.
40A-4
40A
124331