Renault Laguna III Manual page 3401

Rear side door: Stripping - rebuilding
Note:
The order of the operations described below
applies specifically to replacing the rear side door.
The following procedure applies to the rear side
door on the vehicle.
STRIPPING
STRIPPING OPERATION FOR PART CONCERNED
a Disconnect the supply connector from the rear side
door wiring harness.
a Remove:
- the rear side door trim (see Rear side door trim:
Removal - Refitting) (MR 416, 72A, Side opening
elements trim),
- the rear side door sealing film (see Door sealing
film: Removal - Refitting) (MR 416, 65A, Door
sealing),
- the rear side door frame interior trim (see Rear
side door frame interior trim: Removal - Refit-
ting) (MR 416, 72A, Side opening elements trim),
- the anti-fouling seal,
- the rear side door glass run channel (see Rear
side door window run channel: Removal - Refit-
ting) (MR 416, 66A, Window sealing),
- the rear side door pillar exterior trim (see Rear side
door pillar exterior trim: Removal - Refitting)
(MR 416, 56A, Exterior equipment),
- the window winder motor (see Electric window
motor: Removal - Refitting) (MR 415, 87D, Elec-
tric windows - Sunroof) (depending on equipment
level),
- the rear side door sliding window (see Rear side
door sliding window: Removal - Refitting) (MR
416, 54A, Windows),
- the rear side door fixed window (see Rear side
door fixed window: Removal - Refitting) (MR
416, 54A, Windows),
- the rear side door window winder mechanism (see
Rear side door manual window winder mecha-
nism: Removal - Refitting) or (see Rear side
door electric window mechanism: Removal -
Refitting) (MR 416, 51A, Side opening element
mechanisms),
SIDE OPENING ELEMENTS
- the exterior door handle (see Exterior door han-
dle: Removal - Refitting) (MR 416, 51A, Side
opening element mechanisms),
- the rear side door lock (see Rear side door lock:
Removal - Refitting) (MR 416, 51A, Side opening
element mechanisms),
- the rear side door check strap (see Rear side door
check strap: Removal - Refitting) (MR 416, 51A,
Side opening element mechanisms),
- the rear side door moulding (see Rear side door
protective strip: Removal - Refitting) (MR 416,
55A, Exterior protection),
- the rear speakers (see Rear speakers: Removal -
Refitting) (MR 415, 86A, Radio),
- the rear side door wiring.
REBUILDING
I - REBUILDING PREPARATION OPERATION
a Always replace:
- the sealing film,
- the foam pads.
a Order a door fitting kit in addition.
II - REBUILDING OPERATION FOR PART
CONCERNED
a Refit:
- the rear side door wiring,
- the rear speakers (see Rear speakers: Removal -
Refitting) (MR 415, 86A, Radio),
- the rear side door moulding (see Rear side door
protective strip: Removal - Refitting) (MR 416,
55A, Exterior protection),
- the rear side door check strap (see Rear side door
check strap: Removal - Refitting) (MR 416, 51A,
Side opening element mechanisms),
- the rear side door lock (see Rear side door lock:
Removal - Refitting) (MR 416, 51A, Side opening
element mechanisms),
- the exterior door handle (see Exterior door han-
dle: Removal - Refitting) (MR 416, 51A, Side
opening element mechanisms),
- the rear side door window winder mechanism (see
Rear side door manual window winder mecha-
nism: Removal - Refitting) or (see Rear side
door electric window mechanism: Removal -
Refitting) (MR 416, 51A, Side opening element
mechanisms),
47A-12
47A