Renault Laguna III Manual page 3208

CENTRE LOWER STRUCTURE
Centre floor, side section: Description
Note:
For a detailed description of welded connections,
see MR 400.
V4Y or V9X
Note:
During partial or complete replacement of the rear
section of the left-hand side floor, it is necessary to
make two holes with a diameter of 5.2 mm in order
to fit the neck support using two steel rivets with a
diameter of 4.8 mm.
- neck support (part number: 767A00001R).
- steel rivets (part number: 7703072305).
Put the neck support (A) in the position indicated in re-
lation to the square boss (B) .
Drill the 2 holes (C) using a 5 mm drill bit.
Secure the neck support using the steel rivets.
III - POSITIONING OF LOCAL ELECTRICAL
EARTHS
WARNING
To avoid damaging the vehicles electric and elec-
tronic components, the earths of any wiring harness
near the weld area must be disconnected.
Position the earth of the welding machine as closely
as possible to the weld area (see MR 400).
144283
41B-2
41B
121956