Renault Laguna III Manual page 3171

Structural components to be positioned on the repair bench: Description
The jig rests under the subframe mounting unit and is
centred in the threaded hole (A) .
It is used for replacing a complete front half unit.
IMPORTANT
This/these point/s help(s) to ensure axle geometry.
This point aligns the subframe of the front axle in rela-
tion to the body. It has a direct influence on all of the
front axle angles.
2 - Rear axle assembly front mounting
The jig supports the underneath of the rear axle mount-
ing unit and is centred in the pilot hole (B) of the rear
axle mounting.
It is used for replacing a rear side member assembly.
IMPORTANT
This/these point/s help(s) to ensure axle geometry.
This point has a direct influence on the path angle of
the vehicle.
GENERAL INFORMATION
124865
3 - Front sub-frame front mounting
The jig rests under the front subframe attachment posi-
tioning pins and it is fitted in the mounting hole of the
attachment (C) .
It is used when replacing:
- a complete front side member,
- a front half unit.
IMPORTANT
This/these point/s help(s) to ensure axle geometry.
This point directly influences the clearance in the
space of the front axle lower wishbone and therefore
the variations in castor angle and wheel alignment.
40A-41
40A
124870