Table of Contents
Advertisement
•
Take a new power module and insert it as far as possible into the empty slot. Then screw the securing screw
[1] unless the module fits tight in the housing.
•
On the back of the O
ule. Both LED's should be lightened.
•
Readjust the ventilation flap at the front of the O
5.2.3 Replacing the filter pad of Argus OmniBus
The filter pad of the A
RGUS
air. Therefore proceed as follows:
•
Open the ventilation flap as explained in section
•
The filter pad is pined onto the flap. Remove it and pin a new filter in it!
•
Readjust the ventilation flap at the front of the O
As long as the filter pad is not irreversibly blocked, cleaning it with a vacuum cleaner is also
an acceptable method to maintain a good air ventilation within the system!
Barco – Argus Workstation for Windows – DOC-3266-2 – Revision 06 – April 2004
B
switch on the respective power switch and check the LED's on the power mod-
MNI
US
O
B
has to be exchanged in intervals, depending on the grade of pollution of the
MNI
US
B
and tighten the three screws at the upper side.
MNI
US
5.2.1 Opening the front of the Argus
B
and tighten the three screws at the upper side.
MNI
US
__________________________________________________________________________
5. Maintenance
Figure 5-5
removing the power module
OmniBus.
5-7
Advertisement
Table of Contents
