Table of Contents
Advertisement
Carrier Disassembly
Refer to Figure 3-31.
1. Drive Planet Shaft (3E) out of carrier pin holes; forcing
Roll Pin (3G) to sheer off.
2. Hold Planet Gear (3F) and push Planet Shaft (3E) out of
Carrier (3A). Thrust Washers (3B) will slide off shaft as it is
removed.
3. Slide Planet Gear (3F) and two Thrust Washers (3B) out
of Carrier (3A).
31215019
Figure 3-30. Housing Shaft Disassembly
SECTION 3 - CHASSIS & TURNTABLE
4. Using a hammer and punch, drive pieces of Roll Pin (3G)
out of Planet Shaft (3E) and Carrier (3A).
5. Remove both rows of Needle Bearings (3C) and Spacer
(3D) from bore of Planet Gear (3F).
6. Repeat Steps 1 thru 5 for remaining two Cluster Gears
(3F).
3-17
Advertisement
Table of Contents
