Example Configuration - Siemens SINUMERIK 804D sl Commissioning Manual

Example configuration

Overview
The commissioning described in this manual orientates itself on an example configuration of
the SINAMICS drive group.
The following figure roughly shows the components.
• A NCU 710 with:
• A NX 10 with:
• An active line module
Figure 4-1 Example configuration
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
– A single motor module for one motor with SMI (Sensor Module Integrated)
– A double motor module for two motors with SMI
– A single motor module for one motor with SMC (Sensor Module Cabinet)
4
31