Protection Level Fundamentals - Siemens SINUMERIK 804D sl Commissioning Manual

Fundamentals
15.7 Protection levels
15.7.1

Protection level fundamentals

Introduction
You can influence the protection levels used with passwords via softkeys.
Press the "HMI" -> "Password" softkey in the "Startup" operating area. The following softkeys
are available:
• Setting the password
• Change password
• Delete password
Set password
1. Press the softkey "Set password." The "Please enter password:" input window appears.
2. Enter one of the possible default passwords (see table "Protection levels concept") and
Change password
For secure access protection, you should change the default passwords
1. Press the "Change password" softkey. The current access level is displayed in the
2. Mark the area for which you would like to assign the new password. You can select the
3. Enter the new password in the input fields "New password" and "Repeat password."
4. Confirm the entry with the softkey "OK." Both entered passwords must match for the
Delete password
1. Press the softkey "Delete password" in order to reset the access authorization.
Access authorization is not automatically deleted at POWER ON!
Notice
For a system boot in which standard machine data is loaded, the passwords are set to the
default values.
284
confirm the entry with the softkey "OK." A permissible password is set and the valid
access level is displayed. Invalid passwords will be rejected.
window that opens.
following areas here:
– System
– Vendor
– Service
– User
modified password to become valid.
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0