Creating A Control Image (Offline) - Siemens SINUMERIK 804D sl Commissioning Manual

Licensing
14.9 Assigning via Automation License Manager
Requirements
The license information can only be displayed if the Automation License Manager is
communicating with the relevant SINUMERIK control system.
Procedure with current control system (online)
Perform the following actions to display the license information for the control system
currently connected to the Automation License Manager:
1. Open the control system file in the navigation area of the Automation License Manager
2. Enable the default object view: "SINUMERIK".
Procedure with control system change over (online)
Perform the following actions to display the license information for a control system not
connected to the Automation License Manager:
1. Exit the Automation License Manager and all other applications using HMI basic software
2. Switch the active communication parameters to the required control system. For a
3. Start the Automation License Manager
4. Open the control system file in the navigation area of the Automation License Manager
Result
The license information for the control system is displayed in the object area of the
Automation License Manager.
14.9.7

Creating a control image (offline)

Background
It is essential to create a control image (offline) for the following reasons:
• The license information must be later transferred to the hardware.
• The computer (PC/PG) on which the Automation License Manager is installed is not
244
and select the control system (online).
Principle
(e.g. HMI Advanced).
detailed description please refer to section: "General functions" >
"Assigning parameters to the TCP/IP communication with a control system"
and select the control system (online).
simultaneously connected to the Internet and the control system. Consequently, the
license information must be transferred to the hardware in three individual stages.
– Intranet or PTP link to control system: Creating a control image (offline) in the
Automation License Manager
– Internet connection: Transferring license information to the control image (offline) by
means of a license requirement alignment
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0