Table 10-4 Normalization Of Phys. Units Of Machine Data And Setting Data: Machine Data - Siemens SINUMERIK 804D sl Commissioning Manual

NCK start-up
10.2 System data
Index 2 specifies the "linear velocity" (see above).
Example 2:
In addition to the change in example 1, the machine data input/output of linear accelerations
is to be performed in ft/s
Index 4 specifies the "linear acceleration" (see above).
Machine data
Table 10-4 Normalization of phys. units of machine data and setting data: Machine data
Number Name of identifier
General ($MN_ ... )
10220 SCALING_USER_DEF_MASK
10230 SCALING_FACTORS_USER_DEF[n]
10240 SCALING_SYSTEM_IS_METRIC
10250 SCALING_VALUE_INCH
10260 CONVERT_SCALING_SYSTEM
10270 POS_TAB_SCALING_SYSTEM
10290 CC_TDA_PARAM_UNIT
10292 CC_TOA_PARAM_UNIT
102
, instead of m/s (initial state). (the internal unit is mm/s
2 2
Name / remarks
Activation of scaling factors
Scaling factors of physical quantities
Basic system metric
Conversion factor for switchover to inch system
Basic system switchover active
System of measurement of position tables
Physical units of the tool data for CC
Physical units of the tool edge data for CC
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
).
2
Reference
T1