Siemens SINUMERIK 804D sl Commissioning Manual page 242

Licensing
14.9 Assigning via Automation License Manager
Procedure: Creating parameters for the first time
Perform the following actions when creating user-specific communication parameters for the
first time:
1. Create the text file:
2. Open the file MMC.INI with a text editor.
3. Copy the [ GLOBAL ] section from the table given above: "User-specific file: MMC.INI" to
4. Copy the [
5. For all [
6. In all [
7. In the [ GLOBAL ] section replace the string: "
Procedure: Changing the active control system (online)
Perform the following actions to change the active control system (online), i.e. the
SINUMERIK control system with which the Automation License Manager communicates:
1. Close the Automation License Manager.
2. Open the file: <installation drive>:\Siemens\Sinumerik\HMI-Advanced\user\MMC.INI with
3. In the [ GLOBAL ] section, replace the current address string with the section name for
4. Start the Automation License Manager.
Result
After booting the Automation License Manager communicates with the SINUMERIK control
system defined in the user-specific communication parameters.
The control system to which you have switched is represented by an "online" control system
file in the navigation area of the Automation License Manager.
The control system to which the Automation License Manager was connected before
switching is represented by an "offline" control system file, if a control image (offline) exists.
242
<installation drive>:\Siemens\Sinumerik\HMI-Advanced\user\MMC.INI if it does not
already exist.
the open file MMC.INI.
AddressParameter
MMC.INI" to the open file MMC.INI according to the number of available SINUMERIK
control systems.
AddressParameter
unique name.
AddressParameter
address for the corresponding SINUMERIK control system.
for the SINUMERIK control system with which the Automation License Manager must
communicate after booting. (See note "Changing the IP address" above.)
(See note "Changing the IP address" above.)
a text editor.
the SINUMERIK control system with which the Automation License Manager should
communicate after booting.
] section from the table given above: "User-specific file:
] sections replace the string: "AddressParameter" with a
] sections replace the string: "IP-Address" with the relevant IP
AddressParameter
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
" with the section name
CNC Part 1 (NCK, PLC, drive)