Intel; Miscellaneous Signals - Intel Pentium 4 Design Manual

In the 478-pin package / intel 850 chipset family platform
Hide thumbs Also See for Pentium 4:
Table of Contents

Advertisement

R
®
15.7.13

Intel

Checklist Items
AC_SDOUT
AC_SDIN[1],
AC_SDIN[0]
AC_BITCLK,
AC_SYNC
15.7.14

Miscellaneous Signals

Checklist Items
SPKR
TP[0]
FS[0]
®
®
Intel
Pentium
4 Processor / Intel
AC'97
Recommendations
• Requires a jumper to 8.2 k Ω pull-up
resistor. Should not be stuffed for
default operation.
• Requires pads for weak 10 k Ω pull-
downs. Stuff resistor for unused
AC_SDIN signal or AC_SDIN signal
going to the CNR connector.
• If there is no codec on the system
board, then both AC_SDIN[1:0] should
be pulled down externally with
resisters to ground.
• No extra pull-down resistors required.
• No extra pull-down resistors required.
Recommendations
• No extra pull-up resistors
• Effective Impedance due speaker and
codec circuitry must be greater than
50 k Ω or a means to isolate the
resistive load from the signal while
PWROK is low be found.
• Requires external pull-up resistor to
VccSUS3_3
• Route to a test point.
®
850 Chipset Family Platform Design Guide
Schematic Review Checklist
Reason/Impact
• This pin has a weak internal pull-
down. To properly detect a
safe_mode condition a strong pull-
up will be required to over-ride this
internal pull-down.
• AC_SDIN[1:0] are inputs to an
internal OR gate. If a pin is left
floating, the output of the OR gate
will be erroneous.
• When nothing is connected to the
link, BIOS must set a shut-off bit for
the internal keeper resistors to be
enabled. At that point, you do not
need pull-ups/pull-downs on any of
the link signals.
• Some implementations add
termination for signal integrity.
Platform specific.
Reason/Impact
• Has integrated pull-up of between
18 k Ω and 42 k Ω . The integrated
pull-up is only enabled at boot/reset
for strapping functions; at all other
times, the pull-up is disabled.
• A low effective impedance may
cause the TCO Timer Reboot
function to be erroneously disabled.
• This signal is used for BATLOW in
Mobile.
• Not required for desktop.
• ICH2 contains an integrated pull-up
for this signal. Test point used for
manufacturing appears in XOR
tree.
265

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents