Date And Time; Setting Buzzer Cycle End; Choosing Sample Identification Mode - HORIBA ABX Micros 60 User Manual

ABX Micros

4.6. Setting buzzer cycle end

This sub-menu allows the operator to set an audible tone «Beep» when the analysis cycle is
complete:
Setting buzzer
Main Menu
5- Setup
3- Special
Press the «Enter» key
Enter system default Password <123> (or the one defined by the operator).
Press the «Enter» key
6- Buzzer yes/no

4.7. Choosing sample identification mode

This sub-menu will allow the operator to select as to how they want to identify their blood samples.
2 options are available in this submenu.
1- US Mode: allows the operator to type in up to 13 Alphanumeric characters for a blood sample
identification. See Section 3,
2- Standard Mode: allows the operator to enter numbers «Only» from 1 to 99999. See Section 3,
3.1. Sample identification
Choosing sample identification
Main Menu
5- Setup
3- Special
Press the «Enter» key
Enter system default Password <123> (or the one defined by the operator).
Press the «Enter» key
7- ID mode
Select a mode of sample identification
Press the «Enter» key to accept the mode.
Startup results will be printed out in the «US Mode» Only. If «STANDARD Mode» is se-
lect for sample identification, the startup results will not be printed out nor will it print
out the startup status unless startup has failed.

5. Date and Time

This Setup sub-menu will allow the operator to change time (see
date format (see
page 15") on the instrument to accommodate different time zones and geographical locations when
needed.
14 - RAB042FEN - User Manual -
60
3.1. Sample identification
modes, page 3-5 for details.
"5.2. Change the Date Format , page
ABX Micros 60
modes, page 3-5 for details.
"5.1. Change Time , page
15"), and date (see "5.3. Change Date ,
15"),