Troubleshooting; Drain Chambers; Prime Reagents - HORIBA ABX Micros 60 User Manual

ABX Micros
If you cannot see any micro-bubbles moving through tubing or in the chambers, the aperture may
still be blocked. In this case, perform a Concentrated Cleaning Section 6,
ing, page 6-11.

1.3.4. Drain Chambers

This service function will allow the operator to check for proper chamber draining and to maintain
some of the parts of the hydraulic manifold as it flushes waste out of the instrument.
Draining chambers
Main menu
4- Service
2- Drain chambers
Press the «Enter» key
Verify the proper draining of the waste through the waste tubing located on the back of the instru-
ment. if it is not flushing waste sufficiently, check the waste tubing connection and verify that there
is no blockage or crimping of the tubing. Verify that both the WBC and RBC chambers are draining
properly, not slow but fairly rapid. If not, view the troubleshooting Section 6,
page 6-18.

1.3.5. Prime Reagents

This service function will allow the operator to prime reagents either individually or all at once, de-
pending on the type of system you have (Separate Reagents or Minipack).
1.3.5.1. Bottle unit
Priming reagents
Main menu
4- Service
3- Prime
1- Bottle Unit
Select 1- All Reagents or 2, 3, 4 according to reagent to prime
Press the «Enter» key to start the priming
1.3.5.2. Pack unit
If the current Minipack is low, proceed as described in
replace the Minipack and perform the following (step by step instructions will be given on the dis-
play when installing a Minipack)
Replacing Pack
Main menu
4- Service
3- Prime
2- Pack unit
1- Change Pack
Press the «Enter» key to start priming
The «2- Pack Unit » menu provides two more functions:
Select «2- Capacity» to display the analyses # left with the current pack
Select «3- Prime Reagents» to run a priming cycle at any time.
10 - RAB042FEN - User Manual -
60
"1.2.3. Reagent pack connection, page 5"
ABX Micros 60
1.3.6. Concentrated Clean-
2.

Troubleshooting,

to