Special Functions; Changing Operator; Changing (The User) Password - HORIBA ABX Micros 60 User Manual

ABX Micros

4. Special Functions

The «Special» sub-menu will allow the operator to access and edit some of the following sub-menu
functions, such as:
◆"4.1. Changing Operator , page 10"
◆"4.2. Changing (the User) Password , page 10"
◆"4.3. Choosing Startup Cycle, page 11"
◆"4.4. Setting Autocleaning frequency , page 11"
◆"4.5. Printing Instrument Configuration , page 12"
◆"4.6. Setting buzzer cycle end , page 14"
◆"4.7. Choosing sample identification mode , page 14"

4.1. Changing Operator

4 Operator Identifications are available and can be modified.
Changing operator
Main Menu
5- Setup
3- Special
Press the «Enter» key
Enter system default Password <123> (or the one defined by the operator).
Press the «Enter» key
Select 1- Chg. Op. Press the «Enter» key.
Select one of any 4 operator ID's to be edited. 4 Alphanumeric characters can be typed in:
Press the «Enter» key
Use the «Up» or «Down» arrow keys to select the next operator ID to be edited.
Repeat the same steps through to edit the remaining operator ID's.

4.2. Changing (the User) Password

The use of this password allows the operator to:
◆Change the Calibration Coefficients.
◆Enter the Special functions menu.
◆Change the «Password» itself.
Changing operator
Main Menu
5- Setup
3- Special
Press the «Enter» key
Enter system default Password <123> (or the one defined by the operator).
Press the «Enter» key
2- Chg. Password then press the «Enter» key
Use the «Number» keys to enter any combination of 3 numbers
Press the «Enter» key to accept the password change. Press the «Esc» key to save the previ-
ous password.
10 - RAB042FEN - User Manual -
60
Use the «Number keys» to enter up to 4 numbers or use the «Up» or «Down» arrow
keys to enter Alphabetical characters.
ABX Micros 60