Intended Use - HORIBA ABX Micros 60 User Manual

5.5. Identification Label
Fig. 3: Identification label

6. Intended use

The ABX Micros 60
alyzer used for in-vitro diagnostics testing of Whole Blood specimens and Whole Blood component
concentrates.
Important: When analyzing Whole Blood component concentrates, you must
consider the Linear Range of the component parameter and its associated pa-
rameters if any. These concentrates may prematurely pollute the counting ap-
erture when analyzing them. It is suggested that you perform 3 Backflushes
and/or a Concentrated Cleaning after analyzing the concentrates.
The ABX Micros 60
noted according to the system setup (See Section 1,
The Rate of determination is approximately 60 samples per hour in the optimum configuration. The
system is totally automated,including an internal dilution system, and a Graphic printer for record-
ing all test results including flags and graphics.
7. Presentation
The ABX Micros 60, which is small in size, has 8 main parts.
1- The Electrical supply.
2- The Electronic Main board.
3- The Dilution Pneumatics.
4- The Control panel, including a key pad and LCD screen.
5- A Reagent compartment.
OS/OT is a fully automated (Microprocessor controlled) Hematology an-
OS/OT is available in 5, 8, 16, and 18 parameters. These parameters are
1.1. Parameters, page 1-3)
ABX Micros
Introduction
60 - User Manual - RAB042FEN - 11
Intended use