Table of Contents
Advertisement
4. Running Samples
4.1. Preliminaries
1-
Run the Quality Control blood, all 3 levels and verify that the results are within their specified
limits (see Section 4,
1. Quality Control
2-
Mix the blood sample gently and thoroughly.
4.2. US mode
Running analysis
Press the «ID» key and enter the patient Identification (See
Remove the cap from the sample tube.
Place the sample beneath the sample probe, raise the sample tube upwards so that the sam-
ple probe enters into the blood.
Press the manual sample bar and analysis will begin. Press the «Startup» key on the front
panel if the system does not respond to the Manual sample bar.
4.3. Standard mode
Running analysis
Press the «ID» key and enter the Run # (See
Remove the cap from the sample tube.
Place the sample beneath the sample probe, raise the sample tube upwards so that the sam-
ple probe enters into the blood.
Press the manual sample bar and analysis will begin. Press the «Startup» key on the front
panel if the system does not respond to the Manual sample bar.
If the instrument has not been in operation for 1/2 hour and an analysis cycle is initi-
ated, the ABX Micros
wait» will be displayed on the LCD screen. Once the HGB reference cycle is complete,
the message «Press the sampling bar» will appear.
4.4. Automatic Cleaning Cycle
The
ABX Micros
60
reached the programmed cycle limit set in the Setup Menu (see Section 5,
frequency
, page 5-11).
When an Automatic cleaning cycle begins a message will appear on the screen.
A Manual cleaning can be requested at any time by the operator:
Manual Autoclean
Main Menu
4- Service
8- Auto Clean
, page 4-2).
"3.1.2. Standard Mode , page
60
will start a HGB Reference cycle. The message «Please
will perform an automatic cleaning cycle once the analysis cycles have
ABX Micros
Workflow
Running Samples
"3.1.1. US Mode , page
5").
5").
4.4. Setting Autocleaning
60
- User Manual - RAB042FEN - 7
Advertisement
Chapters
Table of Contents
Troubleshooting
