Table of Contents
Advertisement
NC macro at the
end of an
NC program
July 2013
Module 9280 Start the NC macro (Run pallet entry)
The NC macro must be defined in NCMACRO.SYS with the entry PALETT =.
It can only be activated if the control is in the Program Run, Single Block or
Program Run, Full Sequence operating mode, a pallet table is selected, and
no macro or NC program is running.
Call:
PS
B/W/D/K <Pallet number>
PS
B/W/D/K <Line number>
CM
9280
Error code:
Marker
Value
Meaning
M4203
0
No error
1
Error code in W1022
W1022
7
The file entered in the entry PALETT= does not exist.
8
Control is not in the SINGLE BLOCK or FULL
SEQUENCE mode
20
Module was not called in a spawn or submit job
28
An NC program or NC macro is running.
29
Selected file is invalid or does not exist
30
There is no PALETT= entry in the NCMACRO.SYS file
36
NCMACRO.SYS does not exist
In NCMACRO.SYS, use the entry PALEPILOG= to define the complete path
and name of the NC macro that is to be called at the end of an NC program
that was started from the pallet table.
To synchronize the current machine status and the look-ahead calculation with
an NC macro call, see "NCMACRO.SYS" on page 1709.
8.7 Pallet management
1501
Advertisement
Table of Contents
