Configuring An Interface - HEIDENHAIN iTNC 530 HSCI Technical Manual

Configuring an
interface
July 2013
To log your control onto a standard network, proceed as follows:
Enter the code number NET123 in the PROGRAMMING AND EDITING

operating mode.
Press the DEFINE NET soft key

In the Computer name field, enter the name under which the control is to

identify itself in the network.
Select the Interfaces tab. Select the name of the interface (eth0),

connector X26 and press the Configuration button.
In the Settings of the interface under Profile, press the Load button.

Select the profile LAN-DHCP, and press OK to confirm your selection.

All other settings can be left at "Automatically procure", unless required

otherwise for your network.
To leave the Settings, press the OK button.

Then press the OK button again to confirm your changes in the network

settings.
Then restart the control with the Restart button.

10.3 Connecting the iTNC to the Network
1873