Individual Tooth Measurement; Monitoring Of The Rotary Axes And Secondary Linear Axes - HEIDENHAIN iTNC 530 HSCI Technical Manual

Hide thumbs Also See for iTNC 530 HSCI:

Table of Contents

Individual tooth

Monitoring of the

rotary axes and

secondary linear

The TNC attempts to maintain the tolerance from MP6510.0 during the tooth

search for individual tooth measurement. At the same time MP6510.0 is used

to calculate the probing feed rate.

If the tolerance from MP6510.0 cannot be maintained during the tooth search,

e.g. due to the missing spindle accuracy, the TNC attempts to maintain the

tolerance from MP6510.1. If this also cannot be maintained, the error

message Tolerance in MP6510 too small appears.

Enter the first maximum measuring error in MP6510.0.

Enter the second maximum measuring error in MP6510.1.

Maximum permissible measuring error for tool

measurement with rotating tool

0.002 to 0.999 [mm]

First measurement error

Second measurement error

To ensure that the rotary axes and the secondary linear axes are always in a

defined position during the tool measuring cycles:

In MP6585, enter the axes to be monitored.

In MP6586.x, enter the reference coordinate at which the axis should be

located during the tool measuring cycles.

If, during activated monitoring, the nominal position does not match the

position from MP6586.x, an error message is displayed.

Monitoring the position of the rotary and additional linear

axes during the tool measurement cycles

0: Axis is not monitored

1: Axis is monitored

Bit 0 – A axis

Bit 1 – B axis

Bit 2 – C axis

Bit 3 – U axis

Bit 4 – V axis

Bit 5 – W axis

Ref. coordinate for monitoring the position of the rotary

and additional linear axes during the tool measurement

–99 999.9999 to +99 999.9999 [mm] or [°]

HEIDENHAIN Technical Manual iTNC 530 HSCI