External Programming - HEIDENHAIN iTNC 530 HSCI Technical Manual

10.11 External Programming

July 2013
Please remember the following when programming externally for subsequent
transmission:
At the program beginning and after every program block, <CR><LF> or

<LF> must be programmed.
After the End of Program block, <CR><LF> and also <EXT> must be

programmed.
For NC programs, the spaces can be omitted between the individual words.

When reading-in DIN blocks, the asterisk character (*) is not required at the

end of the block.
Comments are separated from the NC block with a semicolon (;).

Comments located before the program are not saved.

With conversational programming, the block numbers are generated by the

iTNC. They need not be programmed.
10.11 External Programming
1929