Itnc 530 And Windows; Ipc 6341—Industrial Pc With Windows 7 - HEIDENHAIN iTNC 530 HSCI Technical Manual

11 iTNC 530 and Windows

11.1 General information and important notes
11.2 IPC 6341—Industrial PC with Windows 7
July 2013
Note
Microsoft Windows, Windows 2000, Windows XP, Windows Vista,
Windows 7 and Internet Explorer are registered trade marks of Microsoft
Corporation.
Note
Please pay attention to the Microsoft End User License Agreement (EULA),
which is included with your product and add it to your machine
documentation.
With the IPC 6341 Windows computer you can start and remotely operate
Windows-based applications via the iTNC's user interface. The user interface
is displayed on the control screen. Software option 133 must be enabled for
this purpose.
Since Windows runs on a separate computer, it does not influence the NC
machining process. The Windows computer is connected to the NC main
computer via Ethernet. A second monitor (VGA) is only necessary for
installation and maybe also for maintenance purposes because the Windows
applications are displayed on the monitor of the iTNC via remote accesses.
Note
Please pay attention to the Microsoft End User License Agreement (EULA),
which is included with your product and add it to your machine
documentation.
When using the IPC 6341, please note the following:
HEIDENHAIN offers no support for the installation of non-HEIDENHAIN

software and cannot guarantee the function of Windows applications.
HEIDENHAIN is not liable for faulty hard disk contents caused by installing

updates to non-HEIDENHAIN software or additional application software.
If such changes in programs or data make service visits from HEIDENHAIN

necessary, the service costs will be invoiced.
The machine manufacturer or end user is responsible for any changes to the

preinstalled Windows system (this especially regards changes to system
settings and the installation of updates or additional software).
11.2 IPC 6341—Industrial PC with Windows 7
1931