Programming Station, Pc Tools And Plce - HEIDENHAIN iTNC 530 HSCI Technical Manual

Hide thumbs Also See for iTNC 530 HSCI:

Table of Contents

station, PC tools

HEIDENHAIN offers the following PC tools for working with the data of the

encrypted partition: PLCdesignNT, PLCtext, CycleDesign and TNCremoNT.

The PLCE partition cannot be accessed until the correct password has been

An encrypted PLCE: partition can be created on the iTNC 530 programming

station as of NC software version 606 42x-02.

To activate the PLCE partition on the iTNC 530 programming station, you must

additionally install a special Windows driver. One driver each for 32-bit

Windows systems and 64-bit Windows systems is provided on the iTNC 530

programming station CD with the ID 535 373 starting with variant 15 (ID

535 373-15). For 32-bit operating systems, the drivers are located in the

\jh\i386 directory of the CD and for 64-bit operating systems in the

\jh\amd64 directory. The basic information about your computer (Control

panel/System) tells you which Windows operating system you are using.

Install your respective driver as follows:

Copy all files of a CD directory for the respective driver into any directory on

your computer, e.g. C:\Programs\iTNC530\606424\Drivers.

Go to Accessories to open a command window or prompt and switch to the

directory into which you have copied the files.

Execute the fdcntl install command

Execute the fdcntl start command

Then you can create, mount and use the PLCE partition as usual.

In the programming station version, the password for the PLCE partition is

saved on the programming station dongle, and not on the SIK. This function is

currently only supported for the blue Aladdin dongle.

To uninstall the driver, please take the following steps:

Go to Accessories to open a command window or prompt and switch to the

directory into which you have copied the files during the installation.

Execute the fdcntl uninstall command.

Please note that after uninstalling the driver, the computer must be

Please note that by uninstalling the driver, the data of the PLCE partition

are not deleted! The PLCE.BIN file is retained, only the driver is

uninstalled. To delete the data, the PLCE partition must be formatted

prior to the uninstallation.

9.3 Hard-Disk Organization