Module 9216 Pop-Up Window With Tool Selection List - HEIDENHAIN iTNC 530 HSCI Technical Manual

July 2013

Module 9216 Pop-up window with tool selection list

Module 9216 opens a pop-up window in which the arrow keys are used to
make a selection for the tool management. The selection list is created by the
NC at the run time for the module. The module responds with the tool or
pocket number for further processing.
Entries using the iTNC keyboard are registered by the pop-up window.

The pop-up window is only shown in the machining modes.

If another pop-up window is active, this window is placed in the background.

After the pop-up window with the selection list is closed, this other pop-up
window is returned to the foreground.
If the pop-up window with the selection list is active, and another pop-up

window is opened, any keystrokes on the iTNC keyboard will be registered
by the second pop-up window, not by the selection list.
The module should be called in its own spawn process, since the module

does not return until the pop-up window is closed, and would therefore
block all subsequent submit jobs.
The window title is displayed in the language set in MP7230.0.

Call:
PS B/W/D/K <Mode>
0: Tools in tool table not in the magazine
1: Tools in tool table in the magazine
2: Empty pockets in the magazine
3: Tools with reserved pockets in the magazine
PS B/W/D/K <Magazine number>
Only for mode 2
PS B/W/D/K <Tool number>
Only for mode 2 (determining the tool type)
CM 9216
PL B/W/D <Tool or pocket number>
–1: Error code in W1022
–2: General error
–3: Selection list closed without selection
–4: Menu file not available
–5: Pop-up window cannot be opened
–6: Selection window already active
–7: Selection window not available
–8: Menu file without selection list
8.15 Tool changer
1583