HEIDENHAIN iTNC 530 HSCI Technical Manual page 1511

Hide thumbs Also See for iTNC 530 HSCI:

Table of Contents

With the exception of the function keys A, B and C, all keys are evaluated by

With MP7670.x, select the subdivision factors for slow, medium and fast

With MP7671.x, define the values for slow, medium and fast speed. The

speed is entered as a percentage of the manual feed rate (MP1020.x).

If MP7641 bit 1 is set, then with MP7672.x you can set the distance per

handwheel step for the HR 410. Different distances per step can be set for

three speed stages.

Evaluation of the keys via the PLC: MP7645.0 = 1

All keys are evaluated by the PLC.

Module 9036 sets the handwheel axis and handwheel subdivision.

With W766 you can influence the feed rate of the axis direction keys.

8.8 Electronic handwheel