——On Pass
——On Fail
——Off
No audible beep sounds.
—
Warning On Off
points that fail are highlighted.
—
Limit Type
Then Fixed or Relative.
—
Offset
Shifts the limit line up or down. Enter an offset value using the rotary knob, the
arrows, or by entering a value with the number keys.
——Enter a positive offset to shift the limit line UP, usually used with UPPER limits.
——Enter a negative offset to shift the limit line DOWN, usually used with LOWER
limits.
—
Margin
Shifts the limit line up or down like an offset, but only virtually. The limit line does
NOT appear to move. Enter a Margin value using the rotary knob, the
entering a value with the number keys.
Enter a positive margin to virtually shift the limit line UP.
Enter a negative margin to virtually shift the limit line DOWN.
How to Save and Recall Limits
— Press Save/Recall then
used for the Save or Recall. Learn more in
— Then press Limit.
— Then choose from the following:
—
Save Limits
After limit lines have been defined, this saves the line definition to a file on the
specified device.
—
Recall Limits
464
Data Analysis Features
All about Limit Lines
Audible beep sounds when a sweep passes.
Audible beep sounds when a sweep fails.
Shows Pass or Fail indication on the display with each sweep. Data
Device
to set the Device (Internal, SD card, or USB flash drive) to be
Recalls a limit Line definition from the specified device.
"Set File Type and Select Device" on page
Keysight N9927-90001 User's Guide
arrows, or by
511.