Vvm Mode Settings; How To Select Vvm Mode; Measurement Selection; Frequency Selection - Keysight N9913A User Manual

VVM (Vector Voltmeter) Mode - Option 308

VVM Mode Settings

VVM Mode Settings
Select VVM Mode before making any setting in this section.

How to select VVM Mode

— Press Mode
— Then

Measurement Selection

How to select a VVM Measurement
— Press Measure 1
— Then choose from the following:

Frequency Selection

How to set Frequency
— Press Freq/Dist
— Then
— Enter a value using the numeric keypad, the
— After using the
— After using the keypad, select a multiplier key. Learn about multiplier

Display Resolution

You can display either one digit or two digits after the decimal point for both
magnitude and phase readings.
336
VVM
— 1-Port Cable Trimming
make this measurement in
on page 341.
— 2-Port Transmission
to make this measurement in
on page 343.
— B/A and A/B 2-port ratioed receiver measurements using external
sources. Learn more in
Frequency
knob.
arrows or the rotary knob, press Enter. The increment
setting of the arrows is based on the current span and can NOT be changed
in VVM Mode.
abbreviations in"Multiplier Abbreviations" on page
1-port reflection measurement. Learn how to
"1-Port Cable Trimming Measurements "
2-port transmission measurement. Learn how
"2-Port Transmission Measurements"
"A/B and B/A Measurements" on page
Keysight N9927-90001 User's Guide
345.
arrows, or the rotary
41.