Reflection Mode (Sa Models) - Option - Keysight N9913A User Manual

Fieldfox analyzers

Hide thumbs Also See for N9913A:

Table of Contents

Keysight Handheld Analyzers

N99xxA User's Guide

14 Reflection Mode (SA Models) - Option 320

Option 320 requires Option 220 Tracking Generator. N9938A models

require Option 100 3.5 mm connectors and Option 220.

Option 320 is not available on N991xA, N992xA, or N995xA models.

This feature may require an option. Please view the FieldFox Configuration

Reflection Mode measurements are very similar to CAT mode reflection

measurements. They provide 1-port scalar reflection measurements in selected

FieldFox SA-Only models. The FieldFox source is routed internally to Port 1

and used to stimulate a Device Under Test (DUT). The energy that is reflected

off the DUT is measured and displayed on the screen.

Option 100 3.5 mm connectors must be installed by the factory. Option

100 is only available on N9938A at the time of purchase. It is not

available as a trial/upgrade.

Option 220 Tracking Generator can be ordered via software license on

www.keysight.com.

http://literature.cdn.keysight.com/litweb/pdf/5990-9836EN.pdf

Table of Contents